Bakers Pride XTG 用户手册
3
1. INSTALLATION INSTRUCTIONS
A.
SAFETY PRECAUTIONS
RETAIN THIS MANUAL FOR FUTURE REFERENCE.
IMPORTANT: Before using your Baker's Pride griddle, the protective coating that was applied at the factory
must be completely removed with a commercial de-greaser. After a through cleaning apply a high
temperature salt free frying oil and your unit is ready to use.
must be completely removed with a commercial de-greaser. After a through cleaning apply a high
temperature salt free frying oil and your unit is ready to use.
B. UNPACKING INSTRUCTIONS:
FOR YOUR SAFETY, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE FOLLOWEDAND ENFORCED.
IFYOU SMELLGAS:
·
·
SHUT OFF GAS SUPPLY TOAPPLIANCE
EXTINGUISH OPEN FLAMES
EXTINGUISH OPEN FLAMES
·
IMMEDIATELYCALLYOUR GAS SUPPLIER
1.
Aseparate gas shut-off valve should be installed in the gas line ahead of the unit, as required by codes.
2.
LIGHTING: Follow the instructions on page 5.
3.
At least 24 inchesmustbeprovidedatthefrontofunitforservicing.
4.
When installing, never enclose the bottom area of the unit with a raised curb or other construction that would
obstruct the flow of air into the unit.
obstruct the flow of air into the unit.
5.
This unit may be operated with 0” (side and back) minimum clearance to non-combustible construction
materials.
materials.
6.
This installationmustconform to local codes, or in absence of local codes to the National FuelGasCodeANSI
Z223.1, latest edition. In Canada it must conform to current National Standard CAN/CGA B 149.1 (natural
gas) or CAN/CGA B 149.2 (propane) Installation Code for Gas BurningAppliances & Equipment.
Z223.1, latest edition. In Canada it must conform to current National Standard CAN/CGA B 149.1 (natural
gas) or CAN/CGA B 149.2 (propane) Installation Code for Gas BurningAppliances & Equipment.
7.
Electrical diagram (model XSG only) is located on the right side of the unit.
8.
The appliance and its individual shut-off valve must be disconnected from the gas supply piping system during
any pressure testing of that system at test pressures in excess of 1/2” psi (3.45 kPa).
any pressure testing of that system at test pressures in excess of 1/2” psi (3.45 kPa).
9.
The appliance must be isolated from the gas supply piping system by closing its individual manual shut-off
valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2”
psi (3.45kPa).
valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2”
psi (3.45kPa).
10.
This appliancemustbeinstalledunder a ventilation hood.
11.
Do not obstruct the flow of combustion and ventilation air.
12.
The area around this or any other gas appliancemustalways be kept free and clear from combustibles.
Carefully unpack the griddle and inspect immediately for shipping damages. Your Griddle was shipped in a
carton designed to give maximum protection in normal handling. It was thoroughly inspected before leaving the
factory and the carrier accepted and signed for it. File any claims for shipping damage or irregularities with the carrier.
factory and the carrier accepted and signed for it. File any claims for shipping damage or irregularities with the carrier.
C. GAS CONNECTIONS
MAIN SHUT-OFF VALVE
PRESSURE REGULATOR
FLUE
Figure “A”