Roland HP-7/3 用户手册

Before You Start Playing

Connect the Pedal Cable

Insert the pedal cable into the Pedal connector on the

rear panel of the HP-7/3.

fig.00-01

Connect the Speaker Cable

(HP-7)

As shown in the diagram, connect the speaker cable

leading from the speaker box of the stand to the

speaker connector located on the rear panel of the HP-7.

Push the speaker cable in until it clicks into position.

NOTE

Do not place containers holding liquids (such as flower vases),

insecticide, perfume, alcohol, or similar substances on top of

this piano.

The speakers of this piano are mounted beneath the upper

surface, and face upwards. Malfunctions or accidents may occur

if liquids contact any part of the speakers.

Connect the Power Cord

Insert the included power cable into the AC inlet on the

bottom panel of the HP-7/3, and then plug it into an

electrical outlet.

NOTE

Be sure to use the supplied power cord.

fig.00-02

Setting Up the Music Stand

(HP-3)

Insert the music stand into the two holes as shown in

the following diagram.

fig.00-03

NOTE

Before moving the piano, be sure to remove the music stand to

prevent accidents.

Setting Up the Music Stand

(HP-7)

Grasping the music stand with both hands, lift it

toward you until its in the upright position.

Use the support on the back of the music stand to
keep the stand in place.

The angle of the music stand can be set to any of three
positions.

fig.mu_stand

HP-3

HP-7

HP-7 Rear

Speaker cable

Speaker connector

Clip portion

Speakers

HP-7/3_e.book 10 ページ２００４年１月２６日　月曜日　午後５時１分