Husqvarna EZ5226 / 965921601 用户手册

OPERATION

Husqvarna-

33

Pump Release Valves
Pump release valves are located at the left and right of 

the pump. They are used to release the system so the 

machine may be moved by hand when not running. 

Tilt seat forward to gain access to the pump. The left 

bypass valve sits directly opposite the right valve. It is 

not visible in the illustration. 
Use a 17 mm open end wrench or socket and ratchet. 

Turn the outer locknut 2-3 turns. Using an 8mm 

wrench or socket, turn the inner nut one turn.
Reverse the procedure to reset the pump, makng sure 

the outer locknut is tightened.

8011-507

ZT-2800 Bypass Linkages
When pushing or pulling the mower, engage the 

ZT-2800 (Integrated Zeroturn Transaxle) bypass 

linkages. The ZT-2800 bypass linkages are located on 

the rear of the frame, below the rear engine guard.

Raise the deck into the highest cutting position.

1. 

Pull the ZT-2800 bypass linkages up and out of 

2. 

the keyhole slots. Release the levers with the 

head outside the frame and held in the bypass 

position.
To reengage the ZT-2800 to drive, reverse the 

3. 

above procedure.

load the machine into truck or trailer by driving up 

ramps in low gear. DO NOT lIfT! The machine is not 

intended to be lifted by hand.

8058-032

8058-032