GE JV332J 用户手册

● 

Have it installed and 

 grounded by a

qualified technician in accordance with the
installation instructions.

● 

Have installer show you the location of the hood

circuit breaker or fuse and mark it for easy
reference.

● 

Take the time to read our suggestions for best use.

●

●

●

●

●

Due to the hood fan drawing power, special
caution is needed to avoid spreading of possible
flame from the cooking surface of your range.
Never leave surface units unattended at high

Boilover causes smoking and greasy

 that may ignite and spread if hood is

used. Use surface unit heat settings recommended
by manufacturer and adequate-size utensils.
When flaming foods are under the hood, 
the fan off. The fan, if operating, may spread the
flame.

or heating the room. The electrical wiring of your
range hood may not withstand the resulting

excessive heat.
Keep hood and grease filters clean according to
instructions to maintain good venting and to avoid
grease fires.
DO NOT USE WATER ON GREASE FIRES.
NEVER PICK UP A FLAMING PAN. Smother
flaming pan with well fitting lid, cookie sheet or
flat tray, and, IF YOU CAN DO 

 WITHOUT

GETTING BURNED, immediately turn “OFF”
the surface unit switch and hood. If there is
danger of being burned, wait until AFTER flame
has been reduced.
Flaming grease outside pan can be extinguished by

baking soda, or, if available, a multi-purpose dry

chemical or foam type fire extinguisher.

● 

recommended in this book. All other servicing
should be referred   a qualified technician.

. Disconnect hood circuit breaker or fuse

You’ll find them on a label on the back wall of the
hood. These numbers are also on the Consumer Product
Ownership Registration Card that came with your

hood. Before sending in this card, please write these
numbers here:

Model Number

Serial Number

Use these numbers in any correspondence or service
calls concerning your hood.

GREASE FILTER

Push out on this clip

to remove filter.

Your hood is equipped with a metal grease filter. When
the fan is operated, air is drawn through the filter and
discharged to the outside.

●

●

●

●

●

Remove the Grease Filter. (See instructions on page 2.)

Remove the wrappings from the filter.

Install the lamp bulb (not provided). See Lamp
Replacement instructions on page 2.

Reinstall the Grease Filter. The hood must not be
operated without the filter in place.

Remove transparent protective film from the front
trim (except Models JV322J and