Rangemaster GLX490 RM 用户手册

 

 

 

 

 

•  Firstly, it is necessary to adjust the two Vr-screws of 

the 11a-brackets, at minimun (B). 

•  Hang the hood body on the two brackets 11a. 
•  Connect the hood to the mains supply by means of a 

bipolar switch with at least 3 mm contact gap. 

• Press the “A”-key for one second (see Part USE) to 

open the upper panel. 

•  Remove the metal filters.   
•  In order to align the hood it is necessary to adjust the 

Vr-screws from inside the hood. 

 •  Fasten the safety screw 11. 
•  Fit again the metal filters into their seats and close the 

upper panel by pressing “L”-key for one second (see 
Part USE). 

•  Disconnect the hood from the mains supply. 

   

  Attention: the upper panel stops if any barrier occurs in its 

way during the panel opening or closing. To open the panel 

it is enough to remove the barrier and press the key once 

again. 

 

When installing the ducted version, connect the hood to 
the chimney using either a flexible or rigid pipe ø 150 
or 125 mm, the choice of which is left to the installer. 
 
•  To install a ø 125 mm air exhaust connection, insert 

the reducer flange 9 on the hood body air outlet and 
the adapting ring ø120-125 10 on the reducer flange. 

•  Fix the pipe in position using sufficient pipe clamps 

(not supplied). 

•  Remove any activated charcoal filters. 

 

9

ø 125

10

ø 150