Sun Microsystems 817-3630-11 用户手册

Chapter 7

Using Windows Server 2003

▼

How to Configure the Network for Windows
Server 2003

After you finish configuring the virtual or the physical network adapter and restart
Windows Server 2003, you need to configure one of the adapters to use TCP/IP. Log
in to Windows Server 2003 again and follow the steps in this procedure.

Caution –

Do not activate a virtual and a physical network adapter at the same

time. Verify that you have disabled the virtual or physical adapter before performing
the following procedure.

1. From the Start menu, choose Settings, and then choose Network Connections.

The Network Connections window opens. The window contains three icons: Make
New Connection, Local Area Connection, and Local Area Connection 2.

Tip –

If you attempt this operation several times, you might see more than the initial

three icons in the window.

2. Right-click Local Area Connection or Local Area Connection 2.

Your choice of 2 or not depends on which Ethernet adapter is enabled. The Status
window opens. A drop-down menu opens.

3. Click Properties.

The Local Area Connection Properties window opens.

4. Double-click Internet Protocol (TCP/IP).

The Internet Protocol (TCP/IP) Properties window opens.

5. Set up TCP/IP for your SunPCi III card as described in “How to Set TCP/IP

Properties” on page 33.

Refer to your Windows Server 2003 documentation if needed.

6. When you finish setting up TCP/IP, click OK to close the Internet Protocol

(TCP/IP) Properties dialog box.

7. Click OK to close the Local Area Connection Properties dialog box.

8. Close the Network Connections window.

Note –

If you see a dialog box with the message

Sunndis failed to start

ignore the message and click OK. This message sometimes appears when DHCP
networking is disabled.