Motorola MVME2400 用户手册

1-4

Computer Group Literature Center Web Site

Preparing and Installing the MVME2400-Series Module

The MVME240x board supports both front panel I/O and rear panel P2 I/O 
through either PMC slot 1 or PMC slot 2. 64 pins of I/O from slot 1 and 46 
pins of I/O from slot 2 are routed directly to P2.

Your MVME240x board must be installed in a VMEsystem chassis with 
both P1 and P2 backplane connections. It requires a single slot, except 
when PMCspan carrier boards are used. Allow one extra slot for each 
PMCspan.

In normal operation, connection of a debug console terminal is required 
only if you intend to use the MVME240x’s debug firmware, PPCBug, 
interactively. An RJ45 connector is provided on the front panel of the 
MVME240x for this purpose.

The following table lists the things you will need to do before you can use 
this board, and tells where to find the information you need to perform 
each step. Be sure to read this entire chapter and read all Caution and 
Warning notes before beginning.

Unpack the hardware.

1-7

Set jumpers on the MVME240x 
module.

1-7

1-7

Prepare the PMCs.

1-13

For additional information on PMCs, refer to 
the PMC manuals provided with these cards.