Mio STANDARD 用户手册
3
INSTALLATION INSTRUCTIONS FOR AQUACHLOR C and SC
INSTALLING THE POWER SUPPLY:
Select a convenient well-ventilated location within one metre of filter equipment and
mount the Power Supply vertically onto a post or wall 1.5 metres above ground level.
Australian Standards requires that the Power Supply shall not be located within 3 meters
of the pool water. Plug Power supply into a suitable weatherproof outlet and plug pump
into power outlet of the Power Supply Unit. The Unit must be kept away from acid and
other chemical storage areas. Acid and chemical vapours will corrode the electronics
inside the Unit. It must also be kept away from heat sources. Good ventilation is
necessary for correct operation (See diagram at bottom of page). Mount unit via
keyholes on back of Unit.
Select a convenient well-ventilated location within one metre of filter equipment and
mount the Power Supply vertically onto a post or wall 1.5 metres above ground level.
Australian Standards requires that the Power Supply shall not be located within 3 meters
of the pool water. Plug Power supply into a suitable weatherproof outlet and plug pump
into power outlet of the Power Supply Unit. The Unit must be kept away from acid and
other chemical storage areas. Acid and chemical vapours will corrode the electronics
inside the Unit. It must also be kept away from heat sources. Good ventilation is
necessary for correct operation (See diagram at bottom of page). Mount unit via
keyholes on back of Unit.
CONNECTING THE ELECTROLYTIC CELL TO THE POWER SUPPLY:
The Power Supply is fitted with a flexible lead terminated with connector’s. These must
be correctly fitted to the connections on the inside of the Cell Head. To prevent incorrect
connection the fittings have been colour coded. The Blue Flow Sensor should be pushed
onto the thread of the small bolt. The power outlet on the bottom of the Power Supply is
dedicated to the POOL PUMP ONLY. Do not use a double adaptor to connect more than
one pump - it can cause overload to the system and could void your warranty.
Important: The Cell must be installed so that the water flows through the Cell Housing
via the Cell head end in accordance with the arrow on the cell housing. This is to ensure
correct operation of the flow sensor. Refer page 9 for connection of pool light on
optional light transformer models.
The Power Supply is fitted with a flexible lead terminated with connector’s. These must
be correctly fitted to the connections on the inside of the Cell Head. To prevent incorrect
connection the fittings have been colour coded. The Blue Flow Sensor should be pushed
onto the thread of the small bolt. The power outlet on the bottom of the Power Supply is
dedicated to the POOL PUMP ONLY. Do not use a double adaptor to connect more than
one pump - it can cause overload to the system and could void your warranty.
Important: The Cell must be installed so that the water flows through the Cell Housing
via the Cell head end in accordance with the arrow on the cell housing. This is to ensure
correct operation of the flow sensor. Refer page 9 for connection of pool light on
optional light transformer models.