Sony 2 用户手册
243
Setup Relating to Switcher Processor
Ch
apt
apt
er 16
E
ngin
eering Se
tup
2
Press [V Blank Mask].
3
Adjust the parameter.
a) Depending on the signal format, the adjustment range varies as follows.
• 480i: 10 to 19
• 576i: 6 to 22
• 576i: 6 to 22
To return the values to their defaults, press [Default].
4
To enable the through mode, press [Through Mode], setting it to Enable.
The through mode can be applied to the following outputs.
The through mode can be applied to the following outputs.
• Aux 1 to 48
• Program outputs of the M/E and PGM/PST rows
• Clean outputs of the M/E and PGM/PST rows
• Program outputs of the M/E and PGM/PST rows
• Clean outputs of the M/E and PGM/PST rows
Making safe title settings
Use the following procedure.
1
In the Switcher>Output menu, press [Safe Title].
The Safe Title menu appears.
The status area shows the output ports and the assigned signals, with the
box 1, box 2, and cross states.
The status area shows the output ports and the assigned signals, with the
box 1, box 2, and cross states.
2
To enable the safe title on/off setting made in the Misc menu, press [Safe
Title], turning it on.
Title], turning it on.
3
Carry out either of the following operations.
To display a box: Press [Box1] or [Box2], turning it on.
In this case, carry out the following steps
4
and
5
.
To display a cross: Press [Cross], turning it on.
4
When you selected [Box1] or [Box2] in step
3
, adjust the following
parameters.
Knob
Parameter
Adjustment
Setting values
2
Mask End
Final value for vertical blanking
interval
interval
See note a) below
Knob
Parameter
Adjustment
Setting values
2
Box Size
Box size
50.00 to 100.00
3
Luminance
Display brightness
0.00 to 100.00
a)