Toshiba SD-M1201 用户手册
,
,
,
,
,
2.5 - 3.5mm
Surface of side or bottom
of DVD-ROM drive
Mounting frame of
host computer
Mounting Screw
M3
6
COMPLETING INSTALLATION
After you have connected all the necessary cables, push the DVD-ROM
completely into the computer’s
drive slot. Mount drive accord-
ing to your computer’s instruc-
tions. The screw length should
not exceed 3±0.5mm (measured
from outside surface of side or
bottom of DVD-ROM to tip of
screw). Replace computer cover
and all outer screws.
drive slot. Mount drive accord-
ing to your computer’s instruc-
tions. The screw length should
not exceed 3±0.5mm (measured
from outside surface of side or
bottom of DVD-ROM to tip of
screw). Replace computer cover
and all outer screws.
Software Driver: The Toshiba SD-M1202 DVD-ROM Drive is “plug n’
play.” When you apply power to your computer and boot-up, it should
recognize the new hardware and prompt you in the installation of the
SCSI driver. If you don’t have the SCSI driver, contact your SCSI host
adapter board manufacturer. After you have completed installing your
DVD-ROM, refer to REALmagic™ User’s Guide to install DVD/MPEG-2
Playback Card.
play.” When you apply power to your computer and boot-up, it should
recognize the new hardware and prompt you in the installation of the
SCSI driver. If you don’t have the SCSI driver, contact your SCSI host
adapter board manufacturer. After you have completed installing your
DVD-ROM, refer to REALmagic™ User’s Guide to install DVD/MPEG-2
Playback Card.
DVD-ROM FRONT PANEL
The photo illustrates the following features of the SD-M1202 DVD-ROM
front panel:
front panel:
①
DVD loading tray
②
Headphone jack
③
Volume control
④
Busy light
⑤
Eject button
⑥
Emergency eject hole (insert solid bar into hole, i.e. paper clip, and
push until tray opens)
push until tray opens)