Fujitsu MBA3147NC 用户手册
(2)
SCSI connector and power supply connector
The connector for the SCSI bus is an unshielded SCA-2 connector conforming to SCSI-3 type
which has two 40-pin rows spaced 1.27 mm (0.05 inch) apart. The power connector is included in
the SCSI connector.
which has two 40-pin rows spaced 1.27 mm (0.05 inch) apart. The power connector is included in
the SCSI connector.
Figure 4.14 shows the SCSI connector. See Section B.1 in Appendix B for signal assignments on
the connector.
the connector.
For details on the physical/electrical requirements of the interface signals, refer to Sections 1.3
“Physical Requirements” and Section 1.4 “Electrical Requirements” of the SCSI Physical
Interface Specifications.
“Physical Requirements” and Section 1.4 “Electrical Requirements” of the SCSI Physical
Interface Specifications.
Figure 4.14 SCA2 type 16-bit SCSI connector
(3)
Connector for external operator panel
This connector is not available for NC model drives.
C141-E270
59