Inglis Home Appliances 2225407 用户手册

Your refrigerator has two front adjustable rollers – one on the right 
and one on the left. If your refrigerator seems unsteady or you 
want the doors to close easier, adjust the refrigerator's tilt using 
the instructions below:

Plug into a grounded 3 prong outlet. 

Move the refrigerator into its final position. 

Remove the base grille (see “Base Grille” earlier in this 
section). The two leveling screws are part of the front roller 
assemblies which are at the base of the refrigerator on either 
side.

Use a screwdriver to adjust the leveling screws. Turn the 
leveling screw to the right to raise that side of the refrigerator 
or turn the leveling screw to the left to lower that side. It may 
take several turns of the leveling screws to adjust the tilt of 
the refrigerator. 

 Having someone push against the top of the 

refrigerator takes some weight off the leveling screws and 
rollers. This makes it easier to adjust the screws.

Open both doors again and check to make sure that they 
close as easily as you like. If not, tilt the refrigerator slightly 
more to the rear by turning both leveling screws to the right. It 
may take several more turns, and you should turn both 
leveling screws the same amount.

Replace the base grille.

If the space between your doors looks uneven, you can adjust it 
using the instructions below:

Pry off the top hinge cover.

Loosen the top hinge screws using a 

⁵⁄₁₆ in. socket or wrench.

Have someone hold the door in place or put a spacer 
between the doors while you tighten the top hinge screws.

Replace the top hinge cover.

Your new refrigerator may make sounds that your old one didn’t 
make. Because the sounds are new to you, you might be 
concerned about them. Most of the new sounds are normal. Hard 
surfaces, such as the floor, walls, and cabinets, can make the 
sounds seem louder. The following describes the kinds of sounds 
and what may be making them.

■

If your product is equipped with an ice maker, you will hear a 
buzzing sound when the water valve opens to fill the ice 
maker for each cycle.

■

Your refrigerator is designed to run more efficiently to keep 
your food items at the desired temperatures and to minimize 
energy usage. The high efficiency compressor and fans may 
cause your refrigerator to run longer than your old one. You 
may also hear a pulsating or high-pitched sound from the 
compressor or fans adjusting to optimize performance.

■

You may hear the evaporator fan motor circulating air through 
the refrigerator and freezer compartments. The fan speed 
may increase as you open the doors or add warm food.

■

Rattling noises may come from the flow of refrigerant, the 
water line, or items stored on top of the refrigerator.

■

Water dripping on the defrost heater during a defrost cycle 
may cause a sizzling sound.

■

As each cycle ends, you may hear a gurgling sound due to 
the refrigerant flowing in your refrigerator.

■

Contraction and expansion of the inside walls may cause a 
popping noise.

■

You may hear air being forced over the condenser by the 
condenser fan.

■

You may hear water running into the drain pan during the 
defrost cycle.