Husqvarna 966067201 用户手册

CoNTRoLS

16

Refer to your engine manual.

Read the safety instructions before fueling. 
Keep the fuel and fuel tank clean. Avoid filling the 
machine with dirty fuel. Make sure the fuel cap is 
properly tightened and the gasket is not damaged, 
particularly before washing the machine.
Use unleaded gasoline with minimum 86 octane 
rating. Never use gasoline mixed with two-cycle oil. 
For ethanol and methanol fuel, the following applies:
Maximum allowable ethanol 10% (volume).
Maximum allowable methanol 5% (volume).
Maximum allowable MTBE (Methyl Tertiary Butyl 
Ether) 15% (volume).
The engine can be damaged if it knocks or pings 
at normal load. Drain the fuel tank and replace with 
fresh fuel. If this does not help, contact an authorized 
service workshop.
Do not fill the tank completely; leave space for the fuel 
to expand as it warms up.

Depth Lever
Use the depth lever to raise and lower the blades 
between working and transport position. The depth 
lever has a lock-out bolt that should be left in until the 
blades wear down. Then move the bolt to a lower hole 
to allow the blades to penetrate the soil.

 Set blade or tine 

depth so that the blades or tines just touch on a 
flat surface such as a sidewalk or driveway.
Delta Blades

 Set blades to penetrate the soil to 

a depth of 

1

/

8

" to ¼"  with a maximum penetration 

of ½". Check seed bag for the manufacture’s 
recommended depth of application
Lawns with deep thatch exceeding ¾" may be 

• 

best dethatched in two treatments (spring and 
fall) to avoid major shock to an older lawn.

8011-019-1

8060-016

The clutch tightens the drive belt and engages the 
drive for the blades. When the clutch lever is pressed 
against the handle, the blades begin to rotate. Hold 
the clutch tightly when working so the belt does not 
slip.