Husqvarna 966067201 用户手册

MAINTENANCE

21

When checking the drive belt, allow the engine to 

1. 

cool.
Remove the spark plug cable.

2. 

Remove the belt guard (see illustration) on the left 

3. 

side of the machine.
Check that the belt is running in the proper track; 

4. 

the pulleys should guide the belt in a straight line.
Check that the belt and pulleys are not oily.  If 

5. 

they are, first try to clean them with spirits. If 
they are heavily coated, take the machine to an 
authorized service workshop to fix the oil leakage 
and replace the belt.

8011-027

DT06

DT07-1

8060-018

Check the belt for cracks, heat damage or worn 

6. 

edges.
Check that guide and tensioning equipment for 

7. 

the belt is not loose and is properly set.
If the belt needs to be replaced - loosen the belt 

8. 

guides.

Remove the old belt.

9. 

Check for wear on the pulleys and replace as 

10. 

necessary.
Check the engine pulley alignment to the rotor 

11. 

pulley and adjust as necessary. The belt should 
run straight.
Fit a new belt by first pulling it over the lower 

12. 

pulley and then the engine pulley. Check that the 
tensioning pulley and belt guides end up outside 
the belt loop.
Tighten belt guides and refit the belt guard.

13.