Husqvarna 323R 用户手册

English

 – 15

1151416-95   Rev. 1  2008-12-23

•

Fit the nut (G). Tighten the nut to a torque of 35-50 Nm 
(3.5-5 kpm). Use the socket spanner in the tool kit. Grasp 
the handle of the spanner as close to the trimmer guard 
as possible.

•

To tighten the nut, turn the spanner in the opposite 
direction to the direction of rotation (Caution! left-hand 
thread).

•

Fit the bottom half of the trimmer head (K) to the cover (I) 
by pressing them together, with the cut-outs on the bottom 
half aligned with the catches on the cover.

•

To dismantle, follow the instructions in the reverse order.

•

Fit the trimmer guard/combination guard (A) intended for 
use with the trimmer head/plastic blades. Hook the guard 
onto the fitting on the shaft and secure it with the bolt (L). 

•

Fit the drive disc (B) on the output shaft.

•

Turn the blade shaft until one of the holes in the drive disc 
aligns with the corresponding hole in the gear housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

Screw on the trimmer head/plastic blades (H) in the 
opposite direction to the direction of rotation.

•

To dismantle, follow the instructions in the reverse order.

At the front is an easily accessible, quick release. Use this if 
the engine catches fire or in any other emergency situation 
that requires you to free yourself from the machine and 
harness.

A well-adjusted harness and machine makes work much 
easier. Adjust the harness for the best working position. 
Tension the side straps so that the weight is evenly distributed 
across both shoulders.

Adjust the shoulder strap so that the cutting attachment is 
parallel to the ground.

Let the cutting attachment rest lightly on the ground. If you 
use a saw blade it should balance about 10 cm above the 
ground to prevent contact with stones and the like. Adjust the 
position of the suspension ring to balance the clearing saw 
correctly.