GE ZIR36N RH 用户手册
26
3/4
″ custom door panel must be routed to
accommodate these door handle extrusions. Rout
the panel as illustrated, 1/4
the panel as illustrated, 1/4
″ deep, and 1-13/16″ wide
on the handle side.
Refer to installation instructions for ZKTR36LH or
ZKTR36RH trim kit for 3/4
ZKTR36RH trim kit for 3/4
″ custom panels:
• Follow Step 1 to remove the standard
aluminum trim.
• Follow Steps 2 and 3 to attach new 3/4
″ trim pieces
and to install panel support brackets.
Right hand door swing models are illustrated in these
instructions. Follow these instructions for left hand
models.
instructions. Follow these instructions for left hand
models.
Tools and materials required:
• #2 Phillips screwdriver
• Drill and appropriate bits
• Custom door panel
• Custom handle
• Safety glasses
• #2 Phillips screwdriver
• Drill and appropriate bits
• Custom door panel
• Custom handle
• Safety glasses
NOTE: This kit must be used in combination with
ZKTR36LH or ZKTR36RH trim kit for 3/4
ZKTR36LH or ZKTR36RH trim kit for 3/4
″
panel trim.
Part List:
A. Handle extrusion (for left hand models)
B. Handle extrusion (for right hand models)
A. Handle extrusion (for left hand models)
B. Handle extrusion (for right hand models)
This kit provides the necessary framework to
install a custom handle, of your choice, onto a 3/4
install a custom handle, of your choice, onto a 3/4
″
thick decorator door panel. (Handles not included.)
The handle extrusion allows the custom handle to be
secured to the door structure, rather than the door
panel.
• Select handle extrusion for your model, discard
The handle extrusion allows the custom handle to be
secured to the door structure, rather than the door
panel.
• Select handle extrusion for your model, discard
other extrusion.
Kit Contents
Before
you begin
you begin
IMPORTANT: Optimal final appearance depends on
careful routing depth. Do not exceed 1/4
careful routing depth. Do not exceed 1/4
″
routing depth.
1-13/16"
Back Side
Handle Side
Custom Panel
1/4" Max.
ZKHTR1 Trim Kit (For 3/4
″ Panels)
Support for Custom Handles