GE ZIS360NM 用户手册

下载
页码 72
– 13 –
Water Valve and Water Tank
The water valve is mounted in the left side of the
machine compartment.
A plastic water line is routed from under the unit,
up the back of the cabinet, into the machine
compartment, and to the water filter.  A line then
goes from the water filter to the water valve.
Two low-pressure plastic water lines supply water
to the icemaker and door dispenser from the water
valve.  A plastic water line is routed from the water
valve, out the back of the machine compartment,
down the back of the cabinet through the bottom of
the unit, and into the fresh food compartment
where it is attached to the cold water tank.  A line is
routed from the cold water tank through the bottom
of the unit into the freezer door to supply the water
dispenser.  The icemaker water line is routed from
the water valve through the machine compartment
to the icemaker.  The icemaker fill tube is also
plastic.
To Replace the Water Valve
Note: Some water may leak from the water supply
line and valve when they are disconnected.
1. Shut off the water supply to the unit.
2. Open the grille panel.
3. Remove 1 Phillips screw attaching the water
valve to the filter bracket.
4. Disconnect the wiring harness connector and
3 water lines from the water valve and remove.
To Replace the Chilled Water Tank
Note: Some water may leak from the water supply
line and valve when they are disconnected.
1. Shut off the water supply to the unit.
2. Remove 2 screws and the chilled water tank
cover inside the fresh food compartment.
3. Remove 2 screws from the chilled water tank.
4. Cut the water lines leaving enough line to
reconnect. Use union WR02X10471
(5/16 x 5/16).
Water Valve
Screw
Screw
Chilled Water Tank
Water Tank Cover
Screws