GE ZISW420DM 用户手册
Monogram.
™
ZISW420DM – GE Monogram 42" Built-In Refrigerator
with Dispenser and Water Filter
41-1/2
7"
5"
Electrical
Area
Area
84 1/2" max
83 1/2" min
Finished
Opening
Opening
74" From Floor
to Bottom
of Electrical
24"
5"
5"
3 1/2"
Water Supply
3 1/2"
42" Models 18"
THE INSTALLATION SPACE
*84" From
Floor to
Top Frame
Floor to
Top Frame
42"
Frame to Frame
41"
Case Width
*83-1/2"
at
Rear
*Shipping height.
The refrigerator
can be adjusted to fit
into a cutout that is
83-1/2” min. to
84-1/2” max. height.
Note that the top
case trim at the front
is 1/2” higher and
will overlap upper
cabinetry or soffit.
Use leveling legs
and wheels for
height adjustment.
can be adjusted to fit
into a cutout that is
83-1/2” min. to
84-1/2” max. height.
Note that the top
case trim at the front
is 1/2” higher and
will overlap upper
cabinetry or soffit.
Use leveling legs
and wheels for
height adjustment.
Specification Revised 8/03
110176
19"
13"
23-7/8"
Behind
Frame
Behind
Frame
26-5/8"
130° Door Swing
90° Door Swing
Water And Electrical Locations
The opening must be prepared with the electrical and water
supply located as shown.
The opening must be prepared with the electrical and water
supply located as shown.
The cutout depth must be 24".
Designed for industry standard flush installation. The refrigerator
will project forward, slightly beyond adjacent cabinetry,
depending on your installation.
Designed for industry standard flush installation. The refrigerator
will project forward, slightly beyond adjacent cabinetry,
depending on your installation.
The cutout depth beneath a soffit:
When installed beneath a soffit, the soffit cannot exceed
the 24" installation depth shown. The top case trim overlaps
the bottom of the soffit.
When installed beneath a soffit, the soffit cannot exceed
the 24" installation depth shown. The top case trim overlaps
the bottom of the soffit.
Frameless cabinets:
The case trim overlaps cabinets at the top and sides.
Therefore, frameless cabinets may require filler strips to
prevent interference with cabinet door swing. The opening
must allow for filler strips.
The case trim overlaps cabinets at the top and sides.
Therefore, frameless cabinets may require filler strips to
prevent interference with cabinet door swing. The opening
must allow for filler strips.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is required. An
• A 115 volt 60Hz., 15 or 20 amp power supply is required. An
individual properly grounded branch circuit or circuit
breaker is recommended. Install a properly grounded 3-prong
electrical receptacle recessed into the back wall.
Electrical must be located on rear wall as shown.
breaker is recommended. Install a properly grounded 3-prong
electrical receptacle recessed into the back wall.
Electrical must be located on rear wall as shown.
Note: GFI (ground fault interrupter) is not recommended.
• Water line can enter the opening through the floor or back wall.
• Water line can enter the opening through the floor or back wall.
The water line should be 1/4" O.D. copper tubing between
the cold water line and water connection location, long
enough to extend to the front of the refrigerator. Installation
of an easily accessible shut off valve in the water line
is recommended.
the cold water line and water connection location, long
enough to extend to the front of the refrigerator. Installation
of an easily accessible shut off valve in the water line
is recommended.
As an ENERGY STAR
®
Partner,
GE has determined that this product
meets the ENERGY STAR
®
guidelines for energy efficiency.
Product Clearances
These refrigerators are equipped with a 2 position door stop.
The factory set 130° door swing can be adjusted to 90° if
clearance to adjacent cabinets or walls is restricted.
These refrigerators are equipped with a 2 position door stop.
The factory set 130° door swing can be adjusted to 90° if
clearance to adjacent cabinets or walls is restricted.
Allow minimum clearances for freezer door and fresh food
door for a full 130° door swing and to allow for pan removal.
door for a full 130° door swing and to allow for pan removal.
4" minimum clearance is required when door swing is adjusted
to 90°. If the 90° door stop position is used, pan access is
maintained, but pan removal is restricted.
to 90°. If the 90° door stop position is used, pan access is
maintained, but pan removal is restricted.
For answers to your Monogram,
®
GE Profile
™
or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center
GEAppliances.com or call
GE Answer Center
®
service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
Underwriters
Laboratories