GE TCD18 用户手册

14

Reversing the Hardware

(For freezer swing door models only.)

Pull out grille 1

″

(25 mm) and set it down on the

floor to gain access to the hinge bracket screws.

Using a 3/8

″

socket, remove the hinge bracket,

screws, plastic washer and spacer shim from the
bottom right side of the cabinet.

Remove plug button and screw from the 
bottom left side of the cabinet and install at 
the bottom right.

Reinstall the spacer shim, hinge bracket, 
screws and plastic washer to the bottom left 
side of the cabinet.

Remove the center hinge bracket and shim by
removing the three screws. NOTE: Keep these
screws with the hinge bracket. They are longer
screws and will be used when installing the hinge
on the other side.

Remove the three painted screws and take
washers from the center left side of the cabinet.
Screw them into the holes on the right side,
which were uncovered in Step “a” above.

Place the center hinge bracket and shim over 
the holes at the center left side of the cabinet.
Insert the three screws that were removed with
the center hinge bracket in Step “a” and 
tighten securely.

Do not install the hinge pin yet.

Interchange hinge and shim at top right with two
plug buttons at top left of cabinet. Do not tighten
screws on hinge side at this time.

Bottom Right

Plastic
Washer

Bottom Left   

Center Right

Center Left

Plastic
Washer