GE GTH21 用户手册

12

Save these

instructions for local inspector’s use.

Observe all

governing codes and ordinances.

Be sure to leave these

instructions with the Consumer.

Keep these instructions

for future reference.

• Skill level – Installation of this appliance requires

basic mechanical skills.

• Completion time – Refrigerator Installation

15 minutes.

• Proper installation is the responsibility of the

installer. 

• Product failure due to improper installation is not

covered under the Warranty.

• Do not install the refrigerator where the temperature

will go below 60°F (16°C) because it will not run often
enough to maintain proper temperatures.

• Do not install the refrigerator where the temperature

will go above 100°F (37°C) because it will not perform
properly.

• Install it on a floor strong enough to support it fully

loaded.

visit our Website at: 

Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.

• Sides 1/8

″ (3 mm)

• Top 1

″ (25 mm)

• Back 1

″ (25 mm)

If the refrigerator is to be installed next to a wall on the
hinge side, allow 5/16

″ (8 mm) door clearance.

If the refrigerator has an icemaker, it will have 
to be connected to a cold water line. A GE water
supply kit (containing tubing, shutoff valve, fittings 
and instructions) is available at extra cost from your
dealer or by visiting our Website at ge.com or Parts 
and Accessories, 800.626.2002.

allow you to move the refrigerator away from the

wall for cleaning.
Leveling Legs

near each front corner of the refrigerator,

next to the rollers, should be adjusted if any of the
following occurs:
• Refrigerator wobbles due to front roller not being firmly

positioned on the floor.

• Door(s) do not close easily when opened to 45°.
NOTE: 
• BEFORE moving the refrigerator away from the wall, 

be sure to turn the leveling legs counterclockwise so that
the weight of the refrigerator is fully transferred to the
front rollers.

• The refrigerator will not be level from front to back. It

will have a slight backward tilt for proper door-closing.

To adjust the leveling legs, 
turn the two front leveling 
legs clockwise to raise the 
front of the refrigerator and
counterclockwise to lower

it.

Clockwise to raise
refrigerator