GE TPS24PBDBS 用户手册

Water Supply to the Icemaker 

You will need to connect the icemaker to a cold
water line.

A water supply kit (containing copper tubing,
shutoff valve, fittings and instructions) is available 
at extra cost from your dealer or from Parts and
Accessories, 800-626-2002. 

Refrigerator Location

Install it on a floor strong enough to support it 
fully loaded.

Clearances

Allow the following clearances for ease of
installation, proper air circulation and plumbing
and electrical connections.

′ 

′ 

′

Sides

1/8

″

(3 mm) 1/8

″

(3 mm)

1/8

″

(3 mm)

Top

1

″

(25 mm)

1/8

″

(3 mm)

1/8

″

(3 mm)

Back

1/2

″

(13 mm) 1/2

″

(13 mm) 1/2

″

(13 mm)

If built-in, allow 7/8

″

(22 mm) for hinge covers.

If the refrigerator is against a wall 
on either side, allow 3/4

″

(19 mm) 

on each side for a 90° door opening.

The rollers can be adjusted so the refrigerator is
firmly positioned on the floor and does not rock
back and forth.

Rollers allow you to move the refrigerator away
from the wall for cleaning. 

To adjust the rollers, remove the base grille by pulling
it out at the bottom.

Turn the two front roller adjusting screws clockwise
to raise the refrigerator, counterclockwise to lower
it. Use a 3/8

″

socket wrench, adjustable wrench or

pliers.

Built-In Style models also have rear adjustable
rollers so you can align the refrigerator with your
kitchen cabinets. Use a 5/16

″

socket wrench to turn

the screws for the rear rollers—clockwise to raise it,
counterclockwise to lower it.

19

Front Roller 
Adjusting Screw

Rear Roller Adjusting Screw 
(on Built-In Style models only).
Use this screw if the refrigerator
has one.

Rear Roller Adjusting Screw 
(on Built-In Style models only).
Use this screw if the refrigerator
does not have the screw pictured
to the left.

Front Roller 
Adjusting Screw

90°