GE 200D8074P043 数据表
Consumer Support
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
About the temperature controls.
GEAppliances.com
The temperature controls are preset in the factory at 37°F for the
refrigerator compartment and 0°F for the freezer compartment. Allow
24 hours for the temperature to stabilize to the preset recommended
settings.
The temperature controls can display both the SET temperature
The temperature controls can display both the SET temperature
as well as the actual temperature in the refrigerator and freezer.
The actual temperature may vary slightly from the SET temperature
based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer
Setting either or both controls to OFF stops cooling in both the freezer
and refrigerator compartments, but does not shut off electrical power
to the refrigerator.
NOTE: The refrigerator is shipped with protective film covering the
temperature controls. If this film was not removed during installation,
remove it now.
The Performance Air-Flow System is designed to
maximize temperature control in the refrigerator and
freezer compartments. This unique special feature
consists of the Air Tower along the back
wall of the refrigerator and the Air Tunnel on the
bottom portion of the freezer rear wall. Placing food in
front of the louvers on these components will not affect
performance. Although the Air Tower and the Air
Tunnel can be removed, doing so will affect temperature
performance. (For removal instructions, on-line, 24 hours
a day, contact us at GEAppliances.com or call
800.GE.CARES. In Canada, contact us at
geappliances.ca or call 1.800.561.3344.)
Performance Air Flow System
To change the temperature,
press and release the
WARMER
or COLDER pad. The SET light will come on
and the display will show the set temperature.
To change the temperature, tap either the WARMER or
COLDER
COLDER
pad until the desired temperature is displayed.
Refrigerator temperatures can be adjusted between 34°F
and 44°F and the freezer temperatures can be adjusted
between
–6°F and +6°F.
Once the desired temperature has been set,
the temperature display will return to the actual
refrigerator and freezer temperatures after
5 seconds. Several adjustments may be required.
Each time you adjust controls, allow 24 hours for the
refrigerator to reach the temperature you have set.
To turn the cooling system off,
tap the WARMER pad for
either the refrigerator or the freezer until the display
shows OFF. To turn the unit back on, press the COLDER
pad for either the refrigerator or freezer. The SET light
will illuminate on the side you selected. Then press the
COLDER
COLDER
pad again (on the side where the SET light is
illuminated) and it will go to the preset points of 0°F for
the freezer and 37°F for the refrigerator. Setting either or
both controls to OFF stops cooling in both the freezer
and refrigerator compartments, but does not shut
off electrical power to the refrigerator.
5