GE GTS21SBXSS 用户手册

15

• Locate the female connector plug. Plug the

onto the male terminals on 

. Either wire can go on either

terminal.

• Fasten the water valve to the cabinet by driving

the Phillips head screw from the kit into the hole
in the cabinet leg.

Female
connector

Male
terminals

Phillips head
screw

•Make sure there is enough plastic water line to

extend from the water valve to well into the 
water tube inlet

. Cut off any excess tubing.

•Squeeze the ends of the hose clamp from the 

kit with pliers and slide the clamp over the water 
tube inlet.

•While still squeezing the clamp, insert the plastic

water line into the inlet as far as it will go
(approximately 1

″ [25 mm]).

•Then slide the clamp downward to capture the

plastic water line in place.

•Make sure the fill tube is aimed down.

Water tube
inlet

• Attach the metal water line clamp (strain relief) 

to the refrigerator. Drive the screw from the kit
through the clamp at the indent into the back 
of the cabinet. 

• The metal clamp is for the house water line (see

the Water Line Installation Instructions). It is not 
to be used for the tubing from the water valve up 
to the icemaker.

Screw

Strain
relief

Hose clamp

Fasten the plastic water line to the back 
of the cabinet with adhesive-backed fasteners,
spacing the fasteners as shown to take up slack
in the line.

Adhesive-backed fasteners 
for plastic water line