Amana XRSS287BB 用户手册
6
What if my doors are not aligned?
•
Locate the higher door, and turn front adjustment screw
counterclockwise. Continue until doors are level.
counterclockwise. Continue until doors are level.
•
If bottom of adjustment range is reached, and doors are
not level–raise opposite door by turning front
adjustment screw clockwise.
not level–raise opposite door by turning front
adjustment screw clockwise.
•
Replace toe grille
Turn both front adjustment
screws (A) clockwise to raise
and counterclockwise to
lower.
2
CAUTION
!
To avoid damage to walls and flooring, protect soft vinyl or other flooring with cardboard, rugs, or other protective material.
To avoid damage or breakage to adjusting bolt, do not use power tools to correct leveling.
DO NOT adjust unit to be any shorter than 173.9 cm tall (minus hinge and cap). Doing so may damage underside
components.
Turn both rear adjustment
screws (B) clockwise to raise
and counterclockwise to
lower.
3
%
$
Check with level to verify 6 mm tilt to the
back for proper door closure.
If unit is aligned and stable, replace toe grille.
4
How to Level Your Refrigerator
Materials Needed
3
/
8
" hex head driver
Level
What if my unit rocks?
•
Turn rear adjustment screw clockwise to raise
rocking corner.
rocking corner.
•
Replace toe grille.
Installing Your Refrigerator
How to Install the Handles
continued
How to Connect the Water Supply
Contact a qualified engineer to perform this task.
Remove Toe Grille and
Bottom Hinge Covers
Open both doors 180°, or as wide as
possible, to remove.
1
To remove after initial install...
Follow steps 2 through 5 in reverse order.
IMPORTANT: To avoid damage to unit, use
a flat blade screwdriver edge wrapped in
masking tape to remove screw plugs.
Insert screw plug into predrilled
hole.
5
Repeat steps 2 through 5 to install
freezer handle.
6
Stainless Steel Handles continued