Frigidaire FFES3015LS 用户手册

23

Before cleaning any part of the appliance, be sure all controls are turned off and the appliance is COOL. REMOVE 

SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANING WILL REDUCE THE NUMBER OF 

MAJOR CLEANING LATER.

Surfaces

How to Clean

Aluminum (trim pieces) & 

Vinyl

Use hot, soapy water and a cloth. Dry with a clean cloth.

Glass, Painted and Plastic 

Body Parts, Control Knobs 

& Decorative Trim Pieces

Using a soft cloth, clean with mild dish detergent and water or a 50/50 solution of vinegar 

and water. Follow by rinsing the area with clean water; dry and polish with a soft cloth. 

Glass cleaners may be used if sprayed on a soft cloth fi rst. DO NOT spray liquids directly 

on the control pad and display area. Do not use large amounts of water on the control 

panel - excess water on the control area may cause damage to the appliance. Do not 

use other liquid cleaners, abrasive cleaners, scouring  pads, or paper towels - they will 

damage the fi nish. To remove control knobs, turn to the OFF position; grasp fi rmly and 

pull straight off the shaft. To replace knobs after cleaning, line up the fl at sides of both 

the knob and the shaft; then push the knob into place.

Control Panels

Before cleaning the control panel, turn all controls to OFF and remove the control 

knobs. To remove, pull each knob straight off the shaft. Clean as instructed above. 

Squeeze excess water from the cloth before wiping the panel; especially when wiping 

around the controls. Excess water in or around the controls may cause damage to the 

appliance. To replace knobs after cleaning, line up the fl at sides of both the knob and 

the shaft; then push the knob into place.

Porcelain Enamel
Burner Grates, Cooktop 

Surface, Below Cooktop, 

Broiler Pan & Insert (some 

models), Door Liner, Oven 

Bottom & Burner Drip Pans

Clean burner grates, broiler pan and insert (some models) in the dishwasher and dry 

upon removal. If soils are not removed, follow the cooktop cleaning instructions below.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 

1:1 solution of clear water and ammonia. If necessary, cover diffi cult spots with an 

ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp 

cloth, then scrub with a soap-fi lled scouring pad. Rinse and wipe dry with a clean cloth. 

Remove all cleaners or the porcelain may become damaged during future heating. DO 

NOT use spray oven cleaners on the cooktop.

Stainless Steel (some models) 

Oven Door & Drawer Front 

Panel and Decorative Trim

Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean water and 

a cloth. Do not use cleaners with high concentrations of chlorides or chlorines. Do not 

use harsh scrubbing cleaners. Only use kitchen cleaners that are especially made for 

cleaning stainless steel. Always be sure to rinse the cleaners from the surface as bluish 

stains may occur during heating that cannot be removed.

Oven Racks

Remove racks. See "To remove and to replace an oven rack" under Oven vent(s) and 

racks. Use a mild, abrasive cleaner, following manufacturer’s instructions. Rinse with 

clean water and dry. After cleaning the racks, rub the sides of the racks with wax paper 

or a cloth containing a small amount of baby oil or salad oil (this will make the racks 

glide easier into the rack positions).

Oven Door

DO HAND 

CLEAN FRAME

DO NOT HAND 

CLEAN OVEN 

DOOR GASKET

DO HAND 

CLEAN DOOR

Use soap & water to thoroughly clean the top, sides and front of the oven door. Rinse 

well. You may use a glass cleaner on the outside glass of the oven door. DO NOT 

immerse the door in water. DO NOT spray or allow water or the glass cleaner to enter 

the door vents. DO NOT use oven cleaners, cleaning powders or any harsh abrasive 

cleaning materials on the outside of the oven door.
DO NOT clean the oven door gasket. The oven door gasket is made of a woven 

material, on Self-Cleaning models, which is essential for a good seal. Care should be 

taken not to rub, damage or remove this gasket.