Smeg CS15-5 用户手册

 

22

 

 

 

 

The oven periodically requires minor maintenance or replacement of wearing parts such as seals, 
bulbs, etc. See below for specific instructions on how to carry out this type of maintenance. 

 

  Before carrying out any such procedure, you must disconnect the electricity supply to the 

 

 
 

 

 

   
  Over time, the taps and the gas oven thermostat may encounter rotation problems and get stuck. 

They should be cleaned internally and the lubrication grease should be replaced. This must be 
carried out by a specialised technician. 

 

 

   

 

 

 

  Remove the bulb protector A by twisting it from left to right; replace bulb B with another equivalent 

bulb (25 W). Remount the bulb protector A. 

 

 

 

 

 

 

 

 

 

 

 

  Take hold of the door with both hands on each side, 

near the hinges A, and lift the levers B. Raise the door 
at a 45° angle and remove it. To remount the door, fit 
hinges  A into the grooves; allow the door to be 
supported towards the base and position the levers B. 

 

 

 

 

 

 

  To enable the oven to be thoroughly cleaned, the door seal can be removed. 

Before removing the seal, the oven door must be demounted as described 
above. Once the door has been demounted, lift the tabs at the corners of the 
seal, as shown in the figure on the right. 

 

914773663/ A