Omega Engineering i.BTX-M 用户手册
5
2.3 Parts of the iServer Unit
Figure 2.3 Parts of the iServer Unit
Table 2.1 Parts of iServer Unit
ETHERNET
RJ45 interface for 10BASE-T connection.
iServer RESET Button: Used for power reseting the iServer board (Ethernet connection).
FLASH RESET Button: Used for power reseting the Flash Memory Card/LCD board.
ACTIVITY
LED (Red) Blinking: Indicates network activities (receiving or sending packets).
NET LINK
LED (Green) Solid: Indicates good network link.
DIAGNOSTICS LED (Yellow) Blinking: Indicates transmitting data from iServer to flash memory card.
When DHCP enabled, it remains solid until DHCP IP address is received.
LED (Green) Blinking: Indicates receiving data by the iServer from flash memory card
LED (Green) Blinking: Indicates receiving data by the iServer from flash memory card
UNITS
Button: Change display units of measurement from °C to °F
TIME
Button: Change display from DATE and TIME to Pressure and Temperature
STBY
Button: Will stop the Flash from recording.
BKLT
Button: Display Back Light
When using the small push buttons, hold the button until “WAIT” is displayed on the LCD and
then release.
then release.
9-12 Vdc
ACTIVITY
NETWORK LINK
DIAGNOSTICS
AND STATUS
NETWORK LINK
DIAGNOSTICS
AND STATUS
iServer Reset Button
iServer LEDs
iServer
RJ45 interface
dc Power Input
Probe
Handle
Clip
Handle
Clip
BAROMETER/TEMPERATURE
UNITS
STBY
TIME
BKLT
ETHERNET
RESET
1
8
Flash
Memory
Card
Reset
Button
Memory
Card
Reset
Button
Flash
Memory
Card
Memory
Card
16 Digit
LCD Display
LCD Display
Buttons
DB9
Connector
Side or Bottom
Wire Entry for
Relay Connector
Wire Entry for
Relay Connector
Removable Plug
Connector for Relays
under the Cover
Connector for Relays
under the Cover
6
1
Mounting
Tabs
Tabs