Raymarine ST1000 Plus & ST2000 Plus 用户手册
Chapter 4: Installing the Tiller Pilot
37
4
In
To measure the critical dimensions:
1. Clamp the tiller on the boat’s center line.
2. Mark dimensions A and B and use masking tape to locate the
2. Mark dimensions A and B and use masking tape to locate the
fixing points.
Note: For standard installations, dimension A is measured on the
starboard side of the cockpit. If you need to mount the tiller pilot on
the port side of the cockpit, you can measure dimension A to port.
However you will need to reverse the tiller pilot’s operating sense
when you have completed installation (see page 52).
starboard side of the cockpit. If you need to mount the tiller pilot on
the port side of the cockpit, you can measure dimension A to port.
However you will need to reverse the tiller pilot’s operating sense
when you have completed installation (see page 52).
3. Make sure that:
•
dimensions A and B are at right angles to each other (as
shown on the diagram opposite)
shown on the diagram opposite)
•
the tiller pilot is mounted horizontally
Basic installation
After establishing control dimensions A and B, you can usually
mount the tiller pilot directly onto the cockpit seat.
mount the tiller pilot directly onto the cockpit seat.
D3192-2
Tiller pin
12.5 mm
(0.5 in)
(0.5 in)
Mounting socket
81130_3.book Page 37 Wednesday, July 25, 2001 11:57 AM