Raymarine ST1000 Plus & ST2000 Plus 用户手册
Chapter 4: Installing the Tiller Pilot
41
4
In
Mounting the tiller bracket
1. Position the tiller bracket on the center line of the tiller (above or
below) and establish the critical dimensions A and B
Note: To measure dimension B on a boat with a sloping rudderstock,
refer to the diagram on page 36.
refer to the diagram on page 36.
2. Mark the centers of the two bracket mounting holes.
3. Drill two 6 mm (
3. Drill two 6 mm (
1
/
4
in) diameter holes through the center line of
the tiller at the positions you have marked.
4. Attach the tiller bracket using two 6 mm (
1
/
4
in) diameter bolts,
nuts and washers.
5. Bond the fixing bolts in place with two part epoxy adhesive
6. When the epoxy is completely hardened, fully tighten the nuts.
7. Attach the tiller pin to the bracket.
6. When the epoxy is completely hardened, fully tighten the nuts.
7. Attach the tiller pin to the bracket.
Cantilever mounting
If you need to attach the tiller pilot to a vertical face (such as the
cockpit sidewall), use a Raymarine cantilever socket assembly
(part number D031):
cockpit sidewall), use a Raymarine cantilever socket assembly
(part number D031):
•
the maximum possible extension offset is 254 mm (10 in)
•
you cut the cantilever to the exact length during mounting
Cutting the cantilever rod to length
1. Clamp the tiller on the boat’s center line.
2. Measure dimension F (actual).
2. Measure dimension F (actual).
E
D3195-2
81130_3.book Page 41 Wednesday, July 25, 2001 11:57 AM