ICOM IC-7000 用户手册
31
3
BASIC OPERATION
When neither the quick tuning step or programmable
tuning step “
tuning step “
Z
” appear, rotating
[DIAL] changes the
frequency in increments of 1 or 10 Hz. These tuning
steps are only available in SSB, CW and RTTY
modes.
steps are only available in SSB, CW and RTTY
modes.
qSelect SSB, CW or RTTY mode if necessary.
wPush and hold [TS] for 1 sec. to toggle between
the 1 Hz and 10 Hz step settings.
• When the 1 Hz step is selected, the 1 Hz digit appears
in the frequency indication; when the 10 Hz step is se-
lected, the 1 Hz digit disappears from the frequency in-
dication.
lected, the 1 Hz digit disappears from the frequency in-
dication.
• Rotating
[DIAL] changes the frequency in 1 Hz or 10Hz
tuning step.
Push and hold
for 1 sec.
Rotating [DIAL] changes the
frequency in 1 Hz steps.
frequency in 1 Hz steps.
Rotating [DIAL] changes the
frequency in 10 Hz steps.
frequency in 10 Hz steps.
[TS]
[MODE]
[DIAL]
DSelecting 1 Hz or 10 Hz step (SSB/CW/RTTY only)
The quick tuning step function allows you to change
the frequency in 1 MHz steps when rotating
the frequency in 1 MHz steps when rotating
[DIAL].
This function is only available in FM, WFM and AM
modes.
modes.
qSelect FM, WFM or AM mode if necessary.
wPush [TS] momentarily to toggle between the 1
MHz tuning step and the programmable tuning
step.
step.
• “
Z
” appears above the 1 MHz indicator when the 1
MHz tuning step is selected.
• Rotating
[DIAL] changes the frequency 1 MHz.
Quick tuning step indicator
Rotating [DIAL]
changes the frequency
in 1 MHz steps.
changes the frequency
in 1 MHz steps.
[TS]
[MODE]
[DIAL]
Appears
D1 MHz quick tuning step (FM/WFM/AM only)