ICOM IC-7000 用户手册

38

3

BASIC OPERATION

qPush [AF(

)] momentarily to enter the set mode

menu.

wPush [F-1 QS] to enter the quick set mode.

ePush [F-1 Y] or [F-2 Z] to select “RF Power.”

rRotate [DIAL] to set the desired output setting.

• Output power is displayed in 1% steps (0% to 100%).

tPush [Z(

)] to exit quick set mode.

•

*Carrier power

[MENU/GRP]

[F-2]

[F-1]

[DIAL]

[AF]

DSetting output power

Microphone gain must be adjusted properly so that
your signal does not distort when transmitted.

qSelect SSB or another phone mode (AM or FM

mode).

wSelect S-1.

ePush [F-3 MET] one or more times to select the

ALC meter.

• “ALC” appears.

rPush [AF(

)] momentarily to enter the set mode

menu.

tPush [F-1 QS] to enter the quick set mode.

yPush [F-1 Y] or [F-2 Z] to select “MIC Gain.”

uPush [PTT] (microphone) to transmit.

• Speak into the microphone at your normal voice level.

iWhile speaking into the microphone, rotate [DIAL]

so that the ALC meter reading does not go outside
the ALC zone.

• Microphone gain is adjusted in 1% steps (0% to 100%).

oRelease [PTT] (microphone) to return to receive.

!0Push [Z(

)] to exit the quick set mode.

• Push

Z(

)] again to return the normal oper-

ating mode.

ALC zone

[MENU/GRP]

[F-3]

[F-1] [F-2]

[DIAL]

[AF]

• Push and hold 

[MENU/GRP] for 1 sec. once or twice

to select the menu group S.

• Push

[MENU/GRP] momentarily one or more times to

select the menu S-1.

DSetting microphone gain

HF

2–100 W

1–40 W

50 MHz

2-100 W

1–40 W

144 MHz

2–50 W

2–20 W

430 MHz

2–35 W

2–14 W

If a linear amplifier is connected such as the IC-PW1/EURO,
set the output power using the ALC meter (see below) to 

the

ALC zone (ALC meter reading should be within this zone),

otherwise the linear amplifier will not work properly.