ICOM IC-F5063 用户手册
This service manual describes the latest service information
for the IC-F5061/F5062/F5063 VHF TRANSCEIVERS at the
time of publication.
for the IC-F5061/F5062/F5063 VHF TRANSCEIVERS at the
time of publication.
NEVER connect the transceiver to an AC outlet or to a DC
power supply that uses more than 15 V. This will ruin the
transceiver.
power supply that uses more than 15 V. This will ruin the
transceiver.
DO NOT expose the transceiver to rain, snow or any liquids.
DO NOT reverse the polarities of the power supply when
connecting the transceiver.
connecting the transceiver.
DO NOT apply an RF signal of more than 20 dBm (100 mW)
to the antenna connector. This could damage the transceiver’
s front end.
to the antenna connector. This could damage the transceiver’
s front end.
To upgrade quality, any electrical or mechanical parts and
internal circuits are subject to change without notice or
obligation.
internal circuits are subject to change without notice or
obligation.
MODEL
VERSION CHANNEL SPACING TX POWER
IC-F5061
USA-01
15.0/30.0 kHz
50 W
IC-F5062
EXP-01
12.5/25.0 kHz
25 W
IC-F5063
EUR-01
12.5/20/25.0 kHz
Be sure to include the following four points when ordering
replacement parts:
replacement parts:
1. 10-digit Icom parts numbers
2. Component part number and name
3. Equipment model name and unit name
4. Quantity required
2. Component part number and name
3. Equipment model name and unit name
4. Quantity required
<SAMPLE ORDER>
1110003491 S.IC TA31136FNG IC-F5061
MAIN UNIT 5 pieces
8820001210 Screw 2438 screw
IC-F5062
Top cover
10 pieces
Addresses are provided on the inside back cover for your
convenience.
convenience.
Icom, Icom Inc. and
logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United
Kingdom, Germany, France, Spain, Russia and/or other countries.
ORDERING PARTS
1. Make sure a problem is internal before disassembling
the transceiver.
2. DO NOT open the transceiver until the transceiver is
disconnected from its power source.
3. DO NOT force any of the variable components. Turn
them slowly and smoothly.
4. DO NOT short any circuits or electronic parts. An
insulated tuning tool MUST be used for all adjustments.
5. DO NOT keep power ON for a long time when the
transceiver is defective.
6. DO NOT transmit power into a signal generator or a
sweep generator.
7. ALWAYS connect a 50 dB to 60 dB attenuator between
the transceiver and a deviation meter or spectrum
analyzer when using such test equipment.
analyzer when using such test equipment.
8. READ the instructions of test equipment thoroughly
before connecting equipment to the transceiver.
REPAIR NOTES
INTRODUCTION
CAUTION