Kawasaki STX-15F 用户手册
ENGINE LUBRICATION SYSTEM 4-21
Oil Pressure Measurement
Oil Pressure Measurement
•
Remove:
Seat (see Hull/Engine Hood chapter)
Inlet Manifold (see Fuel System (DFI) chapter)
Oil Pressure Switch Connector [A] (disconnect)
Oil Pressure Switch [B]
Inlet Manifold (see Fuel System (DFI) chapter)
Oil Pressure Switch Connector [A] (disconnect)
Oil Pressure Switch [B]
•
Install the oil pressure gauge adapter [A] to the switch
hole.
hole.
Special Tool - Oil Pressure Gauge Adapter, PT 1/8: 57001
-1033
•
Install the oil pressure gauge [A] to the adapter.
Special Tool - Oil Pressure Gauge, 10 kgf/cm²: 57001-164
•
Out off a rag or cloth.
•
Install:
Inlet Manifold (see Fuel System (DFI) chapter)
•
Launch the watercraft.
•
Start the engine for several minutes.
•
Run the engine at the specified speed, and read the oil
pressure gauge.
If the oil pressure is significantly below the specification,
inspect the oil pump and relief valve.
If the oil pump and relief valve are not at fault, inspect the
rest of the lubrication system.
pressure gauge.
If the oil pressure is significantly below the specification,
inspect the oil pump and relief valve.
If the oil pump and relief valve are not at fault, inspect the
rest of the lubrication system.
Oil Pressure
Standard: 461 kPa (4.7 kgf/cm², 67 psi) @3 000 r/min
(rpm), oil temperature 74°C (165°F)
•
Stop the engine.
•
Raise the watercraft to the land.
•
Remove:
Inlet Manifold
Oil Pressure Gauge and Adapter
Oil Pressure Gauge and Adapter