Kawasaki STX-15F 用户手册
8-12 ENGINE BOTTOM END
Magneto Flywheel
Magneto Flywheel Removal
•
Remove:
Engine (see Engine Removal/Installation chapter)
Crankshaft Sensor Cover (see Electrical System chap-
ter)
Coupling (see Coupling/Output Shaft Removal)
Magneto Cover (see Coupling/Output Shaft Removal)
Crankshaft Sensor Cover (see Electrical System chap-
ter)
Coupling (see Coupling/Output Shaft Removal)
Magneto Cover (see Coupling/Output Shaft Removal)
○
Using the rotor puller [A], pull off the flywheel [B].
Special Tool - Rotor Puller: 57001-1623
Grip: 57001-1591 [C]
CAUTION
Do not hit the head of the rotor puller. A loss in rotor
magnetism may be caused.
magnetism may be caused.
Magneto Flywheel Installation
•
Using a high-flash points solvents, clean off any oil or dirt
that may be on the crankshaft taper, and in the tapered
hole in the magneto flywheel.
that may be on the crankshaft taper, and in the tapered
hole in the magneto flywheel.
•
Install the O-ring [A] directly as shown.
○
This face [C] is magneto flywheel side.
•
Fit the woodruff key [B] securely in the crankshaft before
installing the magneto flywheel.
If the reduction gear [D] is removed, apply a molybdenum
disulfide grease to both ends of its shaft.
installing the magneto flywheel.
If the reduction gear [D] is removed, apply a molybdenum
disulfide grease to both ends of its shaft.
•
Install the reduction gear and the washer [E].