Kawasaki STX-15F 用户手册
13-18 HULL/ENGINE HOOD
Rubber Parts
Rivet Removal
•
Drill out the rivet with a drill bit [A] of the correct size.
Rivet Removal Drill Bit Size
5.0 mm (0.2 in.)
NOTE
○
Stop drilling when the rivet head [B] starts to turn with
drill bit.
drill bit.
○
Tap the rivet out with a suitable punch and hammer.
Rivet Installation
•
Secure the parts to the hull with the rivets using a riveter
[A].
[A].
Front Bumper Removal
•
Take out the plugs [A].
•
Take out the mounting screw [B] and nuts [C].
•
Drill out the rivets [D] (see Rivet Removal).
•
Remove the front bumper [E].
Front Bumper Installation
•
Secure the front bumper to the hull flange with the rivets
(see Rivet Installation).
(see Rivet Installation).
Rear Bumper Removal
•
Remove the corner bumpers [A] and trim strip [B].
○
Take out the plugs [C].
○
Drill out the rivets [D] (see Rivet Removal).
•
Remove the rear bumper [E].
Rear Bumper Installation
•
Secure the bumpers to the hull flange with the rivets (see
Rivet Installation).
Rivet Installation).