Kawasaki STX-15F 用户手册
14-34 ELECTRICAL SYSTEM
Charging System
•
Tighten:
Torque - Regulator/rectifier Bolts: 7.8 N·m (0.80 kgf·m, 69
in·lb)
•
When installing the bracket, apply a non-permanent lock-
ing agent to the bracket mounting screws and tighten
them securely.
ing agent to the bracket mounting screws and tighten
them securely.
Regulator/Rectifier Inspection
•
With the hand tester set to the R × 1 kΩ range, test the
regulator/rectifier according the following table.
regulator/rectifier according the following table.
Special Tool - Hand Tester: 57001-1394
Regulator/Rectifier Inspection
Unit: kΩ
Tester (+) Lead Connection
Terminal
+
∼
∼
∼
−
+
–
500
∼
∞ 500
∼
∞ 500
∼
∞ 500
∼
∞
(–)*
∼
2
∼
20
–
500
∼
∞ 500
∼
∞ 500
∼
∞
∼
2
∼
20
500
∼
∞
–
500
∼
∞ 500
∼
∞
∼
2
∼
20
500
∼
∞ 500
∼
∞
–
500
∼
∞
−
2
∼
40
2
∼
20
2
∼
20
2
∼
20
–
(–)*: Tester (–) lead Connection
If any of the values obtained do not agree with the above
table, the regulator/rectifier must be replaced.
If any of the values obtained do not agree with the above
table, the regulator/rectifier must be replaced.
Regulator Inspection
○
To test the regulator out of circuit, use three 12 V batteries
and a test light (12 V 3
and a test light (12 V 3
∼
6 W bulb in a socket with leads).
CAUTION
The test light works as an indicator and also as a
current limiter to protect the regulator/rectifier from
excessive current. Do not use an ammeter instead
of a test light.
current limiter to protect the regulator/rectifier from
excessive current. Do not use an ammeter instead
of a test light.
•
Do the 1st step regulator circuit test.
○
Connect the test light and the 12 V battery to the regula-
tor/rectifier as shown.
tor/rectifier as shown.
○
Check infinity (
∼
) terminals respectively.
If the test light turns on, the regulator/rectifier is defective.
Replace it.
If the test light does not turn on, continue the test.
Replace it.
If the test light does not turn on, continue the test.