Garmin Flight Deck 100 用户手册
Embraer Prodigy
®
Flight Deck 100 Pilot’s Guide
190-00728-04 Rev. A
394
HAZARD AVOIDANCE
Unlighted Obstacle
Lighted Obstacle
Obstacle Location
< 1000’ AGL > 1000’ AGL < 1000’ AGL > 1000’ AGL
Red obstacle is above or within 100 ft
below the aircraft altitude
below the aircraft altitude
Yellow obstacle is between 100 ft and
1000 ft below the aircraft altitude
1000 ft below the aircraft altitude
Table 6-13 TAWS-B Obstacle Colors and Symbology
Potential Impact
Point Symbol
Alert Type
Example Annunciation
Warning
Caution
Table 6-14 TAWS-B Potential Impact Point Symbols with Alert Types
TAWS-A PAGE
The Map - TAWS-A Page shows terrain, obstacle, and potential impact point data in relation to the aircraft’s
current altitude, without clutter from the basemap. It is the principal map page for viewing TAWS-A information.
Aviation data (airports, VORs, and other NAVAIDs) can be displayed for reference. If an obstacle and the
projected flight path of the aircraft intersect, the display automatically zooms in to the closest potential point of
impact on the TAWS-A Page.
Aviation data (airports, VORs, and other NAVAIDs) can be displayed for reference. If an obstacle and the
projected flight path of the aircraft intersect, the display automatically zooms in to the closest potential point of
impact on the TAWS-A Page.
Aircraft orientation on this map is always heading up unless there is no valid heading. Two views are available
relative to the position of the aircraft: the 360° default display and the radar-like ARC (120°) display. Map range
is adjustable with the RANGE Knob from 1 to 200 nm, as indicated by the map range rings (or arcs).
is adjustable with the RANGE Knob from 1 to 200 nm, as indicated by the map range rings (or arcs).
Displaying the TAWS-A Page:
1)
Turn the large FMS Knob to select the Map Page Group.
2)
Turn the small FMS Knob to select the TAWS-A Page.
Changing the TAWS-A Page view:
1)
Select the VIEW Softkey.
2)
Select the 360 or ARC Softkey to select the desired view.
Or
:
1)
Press the MENU Key.
2)
Select ‘View Arc’ or ‘View 360º’ (choice dependent on current state) and press the ENT Key to change the view