Cal Flame LTR20091006 用户手册
Installation /
Assemb
ly
17
2009 Fireplaces and Firepits
LTR20091006, Rev. B
www.calspas.com
High Elevation Installation
Your fireplace or fire pit is approved for elevations up to 4500 feet in
the US and Canada.
When installing this appliance at an elevation above 4500 feet in the
When installing this appliance at an elevation above 4500 feet in the
US, it may be necessary to decrease the input rating by changing the
existing burner orifice to a smaller size. Reduce the input by 4% for
each 1,000 feet above sea level, unless the heating value of the gas
has been reduced, in which case this general rule will not apply. To
identify the proper orifice size, check with your local gas utility.
When installing this unit at an elevation above 4,500 feet in Canada
When installing this unit at an elevation above 4,500 feet in Canada
check with your local authorities. Consult the local gas utility for assis-
tance in determining the proper orifice for your location.
Natural Gas Conversion
For Both Fireplaces or Fire Pits
CAUTION: This service is to be completed only by an authorized gas
appliance installer. Do not attempt this conversion on your own as
there is risk of serious injury or death.
To The Authorized Gas Appliance Installer:
All Cal Flame fireplaces and firepits are shipped from the factory
equipped to burn on liquid propane fuel. Enclosed with this kit is a
natural gas conversion kit for converting this unit to natural gas. To
perform this conversion, follow the directions below and to the local
regulation standards in your area.
Make sure unit is not in operation and is cool enough to perform
1.
this service. Shut off and disconnect propane fuel source at the
regulator end.
Carefully remove the storage cover, lava rocks and fire logs. Turn
Carefully remove the storage cover, lava rocks and fire logs. Turn
2.
unit over to access hose connections underneath.
While holding the propane orifice in place with a wrench, unscrew
While holding the propane orifice in place with a wrench, unscrew
3.
brass fitting on fuel inlet hose. Unscrew propane orifice and re-
move.
Using the new brass natural gas orifice re-install the parts in the
Using the new brass natural gas orifice re-install the parts in the
4.
same sequence. Turn the protective screen / air intake sleeve to al-