Jabra GO 6470 用户手册

34

Jabra GO 6470 User manUal

when there is an incoming call, you will hear a ringtone from the phone, Jabra GO base and/or headset. In most 

cases (see below), the touchscreen indicates which phone is ringing and shows the incoming phone number (if 

available). the ringtone played in the headset also indicates which phone is ringing (see also the section “headset 

Controls and Signals). 
to answer a call from any connected phone:

1.  If you have a desk phone without automatic ring tone detection:

-  set the desk phone as the current target by touching the desk-phone icon on the touchscreen or pressing 

the headset’s multifunction button until you hear the desk phone audio indicator (see also the section “the 

target Phone Concept”). 

  In this case, you will hear your desk phone ring but will not hear any ringtone in your headset or see any 

ring indicator on the touchscreen. this preliminary step of making the desk phone the target is necessary.

  Note: this is not necessary if you have a Gn1000 handset lifter or electronic hookswitch connection that 

supports ring detection, nor is it necessary for other phone types.

Open the audio link to the headset by doing one of the following: 

-  tap the headset’s multifunction button, or

-  touch the answer-call icon on the base touchscreen, or

-  lift the headset from the cradle on the base (if automatic opening of the audio link is enabled, see the 

section”headset docking-Operation”). 

then (for desk phones without handset lifter or electronic hookswitch) lift your handset from the receiver, 

setting it aside — or press the headset button, if your desk phone has one.

6.5  hanging uP

to terminate the current call when no calls are on hold, do one of the following:
-  For desk phones without a handset lifter or electronic hookswitch:

  place the desk phone handset back onto its receiver or press the desk phone headset button (if present) 

to terminate the call. then deactivate the audio link to the headset by doing one of the following: tap the 

headset multifunction button, touch the end-call icon on the touchscreen, or dock the headset to the Jabra 

GO base.

  Tap the headset multifunction button, touch the end-call icon on the touchscreen, or dock the headset to the 

Jabra GO base.