Omron C40K 用户手册
183
Appendix C
Programming Console Operations
Name
Function
Page
Data Clear
Used to erase data, either selectively or totally, from the Program Memory and
the IR, AR, HR, DM, and TC areas.
the IR, AR, HR, DM, and TC areas.
Address Designation
Displays the specified address.
Program Search
Searches a program for the specified data address or instruction.
Instruction Insert
Instruction Delete
Instruction Delete
Allows a new instruction to be inserted before the displayed instruction, or
deletes the displayed instruction (respectively).
deletes the displayed instruction (respectively).
Program Check
Checks the completed program for syntax errors (up to three levels in H-type
PCs).
PCs).
Error Message Read
Displays error messages in sequence, starting with the most severe messages.
Bit/Word Monitor
Displays the specified address whose operand is to be monitored. In RUN or
MONTR mode it will show the status of the operand for any bit or word in any
data area.
MONTR mode it will show the status of the operand for any bit or word in any
data area.
Forced Set/Reset
Set: Used to turn ON bits or timers, or to increment counters currently
displayed on the left of the screen.
Reset: Used to turn OFF bits, or to reset timers or counters.
displayed on the left of the screen.
Reset: Used to turn OFF bits, or to reset timers or counters.
Hex/BCD Data Change
Used to change the value of the leftmost BCD or hexadecimal word displayed
during a Bit/Word Monitor operation.
during a Bit/Word Monitor operation.
SV Change
SV Reset
SV Reset
Alters the SV of a timer or counter either by incrementing or decrementing the
value, or by overwriting the original value with a new one.
value, or by overwriting the original value with a new one.
Program Memory Save
Saves Program Memory to tape.
Program Memory Restore
Reads Program Memory from tape.
Program Memory Compare
Compares Program Memory data on tape with that in the Program Memory
area.
area.
System Operations
Operation/Description
Modes*
Key sequence
Data Clear
Unless otherwise specified, this
operation will clear all erasable
memory in Program Memory and
IR, HR, AR, DM, and TC areas. To
clear EPROM memory the write
enable switch must be ON (i.e.,
enabled). The branch lines shown
are used only when performing a
partial memory clear, with each of
the memory areas entered being
retained. Specifying an address will
result in the Program Memory after
and including that address being
deleted. All memory up to that
address will be retained.
Unless otherwise specified, this
operation will clear all erasable
memory in Program Memory and
IR, HR, AR, DM, and TC areas. To
clear EPROM memory the write
enable switch must be ON (i.e.,
enabled). The branch lines shown
are used only when performing a
partial memory clear, with each of
the memory areas entered being
retained. Specifying an address will
result in the Program Memory after
and including that address being
deleted. All memory up to that
address will be retained.
P
CLR
PLAY
SET
NOT
REC
RESET
MONTR
HR
CNT
DM
[Address]
Partial
Clear
Clear
Retained if
pressed
pressed
All Clear
*Modes in which the given instruction is applicable: R = RUN, M = MONITOR, P = PROGRAM