GTO GP-SW050 用户手册

  

Bolts

and

Washers

Reducer

Arm

Key

Closed Gate

Closing

Gate Bracket

Operator Arm

Reducer Arm

(approx)

5°-10° Angle

Clevis Pin

Hairpin Clip

Output Shaft

Fig. 1

Fig. 2

Fig. 5

Fig. 6

Fig. 4

Fig. 3

O

N

NOTE:  Gate Arm’s length can be adjusted

 1.   Install the key into the output shaft. (Fig. 1)

 2.   Fit the end of the reducer arm onto the output shaft as shown and

 

tighten the bolts. (Fig. 2)

 3.   Turn the power on.

 4.   Set DIP switch 1 to designate the operator arm as left or right (Fig. 3)

(right is shown here).

 5.  Manually move gate to the closed position. (Fig. 4)

  6.  Unfold the arm to approximately a 5-10° angle. (Fig. 4)

  7.  Use ‘CLOSE’ button on control board to move operator arm/reducer arm to the gate. CAUTION: Be careful 

not to stand in the gray area surrounding the operator. (Fig. 4) Be prepared to stop (using the ‘STOP’ button) 

when the gate arm and reducer arm near the desired position.

 

NOTE:  Use ‘JOG’ buttons to fine tune the position.

  8.  Mark the position of the gate bracket holes on the gate, drill holes and mount bracket.

  9.  Fit the end of the operator arm into the gate bracket and attach using clevis pin and hairpin clip. (Fig. 5)