Moxa Technologies RS-422 用户手册
3-12
Industio CI-134 Series User’s Manual
Note !
Go directly to the step 7 if you need not change any setting.
6.
In the “Pr oper ty” dialog box, select the desired port in the port list and click
[Por t Setting] to enter the individual “Por t #” setting dialog box to change
the port number mappings or FIFO settings.
[Por t Setting] to enter the individual “Por t #” setting dialog box to change
the port number mappings or FIFO settings.
l
Port Number
You have to set up all the ports of the board with the desired “COM
number ”, which should not conflict with other COM number in use. In
this “Individual Port Setting” dialog box, you may have two ways to map
the physical ports to COM numbers depending on the check box “Auto
Enumer ating COM Number ”.
number ”, which should not conflict with other COM number in use. In
this “Individual Port Setting” dialog box, you may have two ways to map
the physical ports to COM numbers depending on the check box “Auto
Enumer ating COM Number ”.
If “Auto Enumerating COM Number” is checked and specify the COM
number of the first port, subsequent ports are mapped to continuous COM
numbers. For instance, if first port is mapped to COM3, then second port
is mapped to COM4 sequentially.
number of the first port, subsequent ports are mapped to continuous COM
numbers. For instance, if first port is mapped to COM3, then second port
is mapped to COM4 sequentially.
If “Auto Enumerating COM Number” is not checked, specify the COM
number for individual port. For instance, the second port can be out of
sequence, say COM10, while the first port is mapped to COM3.
number for individual port. For instance, the second port can be out of
sequence, say COM10, while the first port is mapped to COM3.