Motorola MBP28/2 用户手册

12

USING YOUR BABY MONITOR

1. The belt clip/stand attaches to the back of the parent 

unit and clips into the locking slots on each side.

NOTE
It will only fit one way, as indicated by UP and the arrows 
on the inside of the clip.
2. The unit comes with the accessory fitted in the belt 

clip mode.

3. You can convert it into the stand mode, by simply 

pulling the back part of the clip out slightly and then 
rotating it by half a turn, as shown above.

Please read these instructions carefully, and be aware 
that this baby monitor is only intended as an aid. It is not 
a substitute for responsible, correct parental supervision.

1. When the parent unit is off, press 

3

 until you hear a 

beep and the Power Indicator starts to flash. The 
parent unit will search for and link itself to the 
registered camera units.

2. When the parent unit is on, press and hold 

3

 until the 

Power Indicator turns off. The parent unit is now 
powered off, although the display may take a few 
seconds to go off fully.

1. When the camera unit is off, press 

0

 to power it on. 

The Power/Link Indicator will flash for a few 
seconds until it links with the parent unit and stays 
steadily on.

2. When the camera unit is on, press and hold 

0

 until 

the Power/Link Indicator turns off. The camera unit 
is now powered off.

Belt clip 
position

Desk position