Sony 4-144-907-43(1) 用户手册

D:\NORM'S JOB\SONY HA\SO0056\STR-DA3500ES\CEL VERSION\GB\4144907431\01GB-
STRDA3500ESUC\070SET_GB.fm

STR-DA3500ES
4-144-907-43(1)

x Test Tone (Test Tone)

• OFF
• AUTO

The test tone is output from each speaker in 
sequence.

• L, C, R, SR, SB, SBR, SBL, SL, SW

You can select which speakers will output 
the test tone.
Some items may not be displayed, 
depending on the setting of the speaker 
pattern.

x Phase Noise (Phase Noise)

• OFF
• L/C, C/R, L/R, R/SL, R/SR, SR/SL, 

SR/SBR, SBR/SBL, SR/SB, SBL/SL, 
SB/SL, SL/L, L/SR
Lets you output the test tone sequentially 
from adjacent speakers.
Some items may not be displayed, 
depending on the setting of the speaker 
pattern.

x Phase Audio (Phase Audio)

• OFF
• L/C, C/R, L/R, R/SL, R/SR, SR/SL, 

SR/SBR, SBR/SBL, SR/SB, SBL/SL, 
SB/SL, SL/L, L/SR
Lets you output the front 2 channel source 
sound (instead of the test tone) sequentially 
from adjacent speakers.
Some items may not be displayed, 
depending on the setting of the speaker 
pattern.

x Sur Back Assign 

• OFF

If you have not connected surround back 
speakers, select “OFF”.

• BI-AMP

If you connect front speakers in a bi-
amplifier configuration, select “BI-AMP”.

• ZONE2

If you are using the surround back speakers 
in zone 2, select “ZONE2”. When you select 
“ZONE2”, the input to the SUR BACK jacks 
of the MULTI CHANNEL INPUT is invalid.

Set “Sur Back Assign” to “OFF”, then connect the 
surround back speakers to this receiver when you 
want to change the connection from a bi-amplifier 
connection or a zone 2 connection to a surround 
back speakers connection. Set up the speakers again 
after you connect the surround back speakers. See 
“9: Calibrating the appropriate speaker settings 
automatically (Auto Calibration)” (page 44) or 
“Adjusting the speaker settings manually” 
(page 65).

x Crossover Freq

Lets you set the bass crossover frequency of 
speakers that has been set to “SMALL” in the 
Speaker settings menu. Measured speaker 
crossover frequency is set for each speaker 
after the Auto Calibration.
The adjusted value is set for each speaker 
when you adjust the speaker crossover 
frequency using “Crossover Freq” after the 
Auto Calibration.