3com 2200 用户手册

C

HAPTER

 3: C

ONFIGURING

 M

ANAGEMENT

 A

CCESS

 

TO

 

THE

 S

YSTEM

You might want to delete all entries from the ARP cache if the MAC address 
has changed. 

To remove all entries from the ARP cache, enter the following command 
from the top level of the Administration Console:

The ARP cache entries are immediately removed from the table.

You can select a RIP mode that is appropriate for your network. RIP can 
operate in one of two modes:

■

Off — The station ignores all incoming RIP packets and does not generate 
any RIP packets of its own.

■

Passive — The station processes all incoming RIP packets and responds to 
explicit requests for routing information, but it does not broadcast periodic 
or triggered RIP updates.

By default, RIP operates in passive mode. 

To set the RIP operating mode:

1 From the top level of the Administration Console, enter:

2 Enter the RIP mode (

or 

). To use the value in brackets, press 

[Return] at the prompt.

See the following example:

Select RIP mode (off, passive) [passive]: 

Once you have set up your IP interface, you might want to check to see if 
the Switch 2200 system can communicate with other systems over the IP 
network. To check, you can “ping” the IP address of your management 
station.

system
ethernet
fddi
bridge

➧

ip
snmp
analyzer
script
logout

interface
route

➧

arp
rip
ping
statistics

display
remove

➧

flush

system
ethernet
fddi
bridge

➧

ip
snmp
analyzer
script
logout

interface
route
arp

➧

rip
ping
statistics