Lightolier IS_CACS 产品宣传页

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

(NOTE: If custom length is required see page 2.) 
 
1. Assemble STEM to BALL ALIGNER using set screws. Pull wires  
   through BALL ALIGNER leaving no less than 6" exposed.  
2. For sloped ceilings, position opening in CROSSBAR facing   
    upward. (Fig. 2) Install CROSSBAR using OUTLET BOX SCREWS.   
3. Place BALL ALIGNER of STEM into CROSSBAR through side 
    access hole. When seated the BALL ALLIGNER keyway will line up 
    with TAB on CROSSBAR. 
4. Slide SAFETY STRAP into position and secure in position with        
    screw. 
5. Make Connections.  Bare Copper and/or green insulation wire(s) 
    must be connected to SUPPLY GROUND.  Connect WHITE  
    LEAD to NEUTRAL (WHITE) SUPPLY LEAD.  Connect BLACK  
    LEAD to HOT SUPPLY LEAD.  Use wire nuts (local hardware 
    items).  Push spliced leads into outlet box. 
 
6. Slide CANOPY over CROSSBAR and push up against ceiling. 
7. Insert SUPPORT COVER onto stem, secure with LOCK WASHER 
    and LOCK NUT. 
 

FIG. 1

OUTLET BOX 
SCREWS

CROSSBAR

CANOPY

BALL ALIGNER

SAFETY STRAP

SUPPORT
COVER

SCREWS

STEM

LOCK NUT

LOCK WASHER

OCTAGON
OUTLET BOX
(BY OTHERS)

45° MAX.

FIG. 2

STEM

BALL ALIGNER

CROSSBAR

SAFETY STRAP

 COMPANY

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.  To 

assure full compliance with local codes and regulations, check with your local electrical inspector before 

installation.  To prevent electric shock, turn off electricity at fuse box before proceeding.