GE AE1RD14DM 用户手册

• If an awning is built over the unit to prevent direct

sunlight or rain exposure, make sure that heat
radiation from the condenser is not restricted.

• Ensure that the space around the back and sides 

is more than 12

″

. The front of the unit should have

more than 79

″

of space.

• Install in a location that is strong enough to permit

safe installation and to withstand the full weight
and vibration of the unit.

• Construct and anchor a strong and level mounting

base or pad for the outdoor unit.

• Anchor the outdoor unit through its four mounts,

using bolts.

• Select a location from which noise and outflow 

air emitted by the unit will not inconvenience
neighbors.

• In humid locations, the unit may sweat and

condensation (water) may drip from it. Take this 
into consideration when choosing the location.

• Select a location that has sufficient ventilation.
• Do not cover the inlet and outlet.
• Install unit away from flammable gas or corrosive

gas leaks.

• Be sure the installation conforms to the installation

dimension diagram.

If the outdoor unit is installed on a roof structure,
be sure to level the unit. Ensure the roof structure
and anchoring method are adequate for the unit
location. Consult local codes regarding rooftop
mounting.

• Do not allow any heat or steam near the unit.
• Select a location where there are no obstacles 

in front of the unit.

• Make sure that condensate drainage can be

conveniently routed away.

• Do not install near a doorway.
• Ensure that the space around the left and right 

of the unit is more than 6

″

. The unit should be

installed as high on the wall as possible, allowing 
a minimum of 6

″

from ceiling.

• Use a stud finder to locate studs for mounting and

to prevent unnecessary damage to the wall.

• Install on studs and in a location from which 

the condensation water can be drained out
conveniently and that permits easy connection 
with the outdoor unit.

• Do not cover the inlet and outlet so that the 

outflow air can reach all parts of the room.

• Install in a location that is strong enough to

withstand the full weight and vibration of the unit.

• Be sure that the installation conforms to the

installation dimension diagram.

• Leave enough space to allow access for routine

maintenance. The height of the installed location
should be 79

″

or more away from the floor.

• Install in a location that is 3 ft. or more away from

other electrical appliances, such as televisions and
audio devices.

• Select a location that gives you easy access to

remove and clean the filter.

More than 6”

More 
than 6”

More than 79”

More 
than 6”

More than 12”

More than 79”

More than 12”

The platform must
support a minimum of
200 lbs. See 

Dimensions for mounting
hole spacing.