Philips MCD149/12 用户手册

35

See "Preparations-Step 2: Setting the clock".

●

The system can be used as an alarm clock,
whereby DISC, USB or TUNER is switched on at a
set time (one time operation). The clock time
needs to be set first before the timer can be used.

1

In standby mode, press and hold SLEEP/
TIMER

 on the remote control for more than

three seconds.

➜

"

SELECT SOURCE" is displayed briefly.

2

Press DISC, USB or TUNER to select your
desired source and press SLEEP/TIMER to
confirm.

➜

"

SET ON TIME" is displayed briefly. Then, the

hour digits flash on the display screen.

●

Before setting timer, make sure the music source
has been prepared.
DISC

 – load the disc.

– connect a suitable USB device.

 – tune to the desired radio station.

3

Press VOLUME +/- on the front panel or VOL
+/-

 on the remote to set the hours and press

 to confirm.

➜

The minute digits flash on the display panel.

4

Press VOLUME +/- on the front panel or VOL
+/-

 on the remote to set the minutes and press

 to confirm.

➜

The timer is now set and activated.

5

In standby mode, press SLEEP/TIMER on the
remote control to activate or deactivate the
timer.

➜

Display shows 

 if activated, and disappears

if deactivated.

The sleep timer enables the system to switch off
by itself after a set period of time.

1

In active mode, press SLEEP/TIMER on the
remote control repeatedly to select a preset
time.

➜

The selections are as follows (time in minutes):

OFF ™ SLEEP 90 ™ SLP 80 ™ SLEEP 70 ™

SLEEP 60 ™ SLEEP 50 ™ SLEEP 40 ™

SLEEP 30 ™ SLEEP 20 ™ SLEEP 10™ OFF

➜

“

SLEEP XX“ or “OFF” is displayed. “XX“

denotes the time in minutes.

2

When you reach the desired length of time, stop
pressing the SLEEP/TIMER button.

●

Press SLEEP/TIMER repeatedly until "

OFF" is

displayed, or press ECO POWER/STANDBY
ON

 y (or y on the remote).

2;

4

pg001-pg039_MCD149-12-Eng

2007.9.13, 15:35

35