KRAM Xpress mutecable 85522 产品宣传页

 

Xpress  - mutecables  are designed to interface between the 
car radio and vehicle harness. It enables the use of one of the 
car speakers when answering/making calls from your cell 
phone. It also provides power supply for the handsfree kit and 
mutes the radio in order to let the conversation be heard. 
Normally no vehicle wires needs to be cut. 
 
Speaker-function: This is achieved by connecting the carkit di-
rectly to one of the car speakers. By using the carkits built-in 
relays, the telephone conversation is send through the car 
speaker, while the radio is muted. This way you will achieve a 
perfect handsfree sound without interference from the car ra-
dio. 
 
Power supply of the carkit: All Xpress mutecables are deliv-
ered with a power connector for the carkit. That way you 
avoid cutting the cars wiring loom. 
 
Note 1: This cableset is designed to plug directly into the FWD 
Audio Profi and Audio 2000 carkits. Use of this Xpress mute-
cable with other carkits require a Carkit-specifik Xpress adap-
tor cable. 
 
Note 2:  The cableset is only to be used for cars without sepa-
rate amplifiers or active loudspeakers. 

Xpress - 

mutecables

Xpress - 

mutecables

 

1st. Remove the radio/radio-unit from the car following the 
manufacturers guide.  
 
2nd. Disconnect the Fakra connector from the radio. 
 
3rd.  Connect the female end of the Xpress mutecable to the 
cars wiring loom and connect the male end to the connector 
at the back of the radio.  
 
4rd.  Check the configuration of the permanent plus and the 
ignition power supply wires, as they in some vehicles can 
be switched. The ignition wire is the blue wire in the 8 way 
FWD connector, and the permanent is the red wire. 
 
5rd. Check the mute position. The mute position can varies 
according to each model. and year of the vehicle, but it is 
usually found at a prefitted position chosen by Kram Tele-
com. The mute wire is the yellow wire in the 8 way FWD 
connector. 
 
6rd. 

Some fakra connectors, on the cars wiriong loom, has 

small connectors fitted to one or two of the bottom slots. 
These are often for CD-changer connection or External radio 
displays. These small connectors will have to be moved to the 
Fakra connector that is fitted to the back of the radio. The 
same goes for Optic wires.

 

 
7rd. Refit the radio.