Acronis Backup & Recovery 10 Adv WS TIDLBPDES 用户手册
产品代码
TIDLBPDES
[Volume] [Letter]:
Disk # /Volume (p. 219)
Sequentially map each of the source volumes to a volume or an unallocated space on the
destination disk.
destination disk.
Size (p. 219):
[Optional] Change the recovered volume size, location and other properties.
Volume destination
To specify a destination volume:
1. Select a volume or unallocated space where you want the selected volume to be recovered to.
The destination volume/unallocated space should be at least the same size as the uncompressed
image data.
image data.
2. Click OK.
All the data stored on the target volume will be replaced by the backed up data, so be careful and watch out for
non-backed-up data that you might need.
non-backed-up data that you might need.
When using bootable media
Disk letters seen under Windows-style bootable media might differ from the way Windows identifies
drives. For example, the D: drive in the rescue utility might correspond to the E: drive in Windows.
drives. For example, the D: drive in the rescue utility might correspond to the E: drive in Windows.
Be careful! To be on the safe side, it is advisable to assign unique names to the volumes.
The Linux-style bootable media shows local disks and volumes as unmounted (sda1, sda2...).
Volume properties
Resizing and relocating
When recovering a volume to a basic MBR disk, you can resize and relocate the volume by dragging it
or its borders with a mouse or by entering corresponding values in the appropriate fields. Using this
feature, you can redistribute the disk space between the volumes being recovered. In this case, you
will have to recover the volume to be reduced first.
or its borders with a mouse or by entering corresponding values in the appropriate fields. Using this
feature, you can redistribute the disk space between the volumes being recovered. In this case, you
will have to recover the volume to be reduced first.
Properties
Type
A basic MBR disk can contain up to four primary volumes or up to three primary volumes and
multiple logical drives. By default, the program selects the original volume's type. You can change this
setting, if required.
multiple logical drives. By default, the program selects the original volume's type. You can change this
setting, if required.
•
Primary. Information about primary volumes is contained in the MBR partition table. Most
operating systems can boot only from the primary volume of the first hard disk, but the number
of primary volumes is limited.
If you are going to recover a system volume to a basic MBR disk, select the Active check box.
Active volume is used for loading an operating system. Choosing active for a volume without an
operating systems can boot only from the primary volume of the first hard disk, but the number
of primary volumes is limited.
If you are going to recover a system volume to a basic MBR disk, select the Active check box.
Active volume is used for loading an operating system. Choosing active for a volume without an
Copyright © Acronis, Inc., 2000-2009
219